I have a 93 chev astro van that will start and run great for ten or so minutes then it will die and not start again for three hours. After three hours it starts up and runs great for another ten minutes then dies and wont start again. any ideas whats wrong?
Try to see what's missing when NOT starting - fuel or spark. If it will sputter with a shot of starting fluid then check fuel pressure,
T
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
I just checked the spark it has good spark. and the fuel pump does do its two second prime. Ok: Now gotta get a good pressure reading when down. KOEO check. GMs can be very fussy about being exactly within range,
T
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
In Reply To
Ok: Now gotta get a good pressure reading when down. KOEO check. GMs can be very fussy about being exactly within range,
T This was listed for the TBI 4.3 below. I'd be interested in "key on engine off" as well as it might not run. Look for fuel rail and a cap (perhaps a blueish/aqua) and a larger than a tire valve fitting for a fuel gauge. Not sure of thread size but they may rent a gauge for this at some parts outlets.....
T
***************************** Fuel System Pressure
For your 1993 Chevrolet Truck Astro Van 2WD 4.3L TBI : 9-13 PSI(Pounds per Square Inch) Note: Position the ignition switch and the A/C system in the off position. Install a fuel pressure gauge to the vehicles fuel rail supply line. Place the ignition switch in the on position, confirm that no leaks are present, and start the engine. Visually verify the fuel pressure reading on the gauge.
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
Car Repair Talk's forum.
T
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
I just checked the spark it has good spark. and the fuel pump does do its two second prime. Ok: Now gotta get a good pressure reading when down. KOEO check. GMs can be very fussy about being exactly within range,
T
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
In Reply To
Ok: Now gotta get a good pressure reading when down. KOEO check. GMs can be very fussy about being exactly within range,
T This was listed for the TBI 4.3 below. I'd be interested in "key on engine off" as well as it might not run. Look for fuel rail and a cap (perhaps a blueish/aqua) and a larger than a tire valve fitting for a fuel gauge. Not sure of thread size but they may rent a gauge for this at some parts outlets.....
T
***************************** Fuel System Pressure
For your 1993 Chevrolet Truck Astro Van 2WD 4.3L TBI : 9-13 PSI(Pounds per Square Inch) Note: Position the ignition switch and the A/C system in the off position. Install a fuel pressure gauge to the vehicles fuel rail supply line. Place the ignition switch in the on position, confirm that no leaks are present, and start the engine. Visually verify the fuel pressure reading on the gauge.
_________________________________________
Tom Greenleaf - MetroWest, Boston
http://acsource.net/acforum/index.php
Car Repair Talk's forum.
Pre:'95 Ford Escort - brakes constantly applied? Next:1996 Quest - Extended Crank
front end problem
loose spark plug
car shakes from side 2 side at low speed
Gas Mileage Drops after Computer Update
2001 Dodge Caravan SE 3.3L Engine Swaped
1999 Saturn SL2 Need help repairing Manual Transmission Gear
Need help with 1995 Toyota Tacoma
1998 jeep won't start
Car Parts: Air Conditioning System / Body / Lighting and Signaling System
OBD-Ⅱ Trouble Codes:OBD-Ⅱ Trouble Codes
P0108 | P0135 | P0171 | P0174
P0300 | P0320 | P0325
P0401 | P0420 | P0430 | P0440 | P0441 | P0442 | P0455
links:Car Logo / Autoi / Car Repair Talk's forum / Car Specifications