Difficulty: ChallengingInstructionsThings You'll Need:
- Engine hoist
- Large bucket
- Socket wrench
- Replacement drain plug gasket
- Cutting tool
- Rubber mallet
- Clean shop rags
- Solvent
- Replacement oil pan gasket
- 5.5 to 6 qt. clean motor oil
- Funnel
- Empty milk carton
- Step 1
Disconnect the negative battery cable and remove the air intake duct. If your Subaru Outback is turbocharged, remove the mass air flow sensor, air intake boot and air cleaner upper cover and intercooler. Remove the front oxygen sensor, pitching stopper and upper radiator brackets.
- Step 2
Support the engine safely with a hoist and remove the front wheel and tire. Lift the engine enough to remove the engine undercover.
- Step 3
Place a bucket under the oil pan drain plug and remove the plug with a socket wrench. Let the oil drain into the bucket and once it's drained, replace the drain plug, along with a new drain plug gasket.
- Step 4
Remove the rear O2S oil connector, exhaust pipe and the nuts that hold the front engine mounts to the crossmember and the nuts and bolts holding the oil pan in place. Divide the upper and lower oil pans with a cutting tool, and use a rubber mallet to remove the pan from the engine.
- Step 5
Clean the old gasket from the mating surfaces, then wipe them with solvent. Run a thin bead of sealant to the new gasket Reinstall the oil pan and tighten the bolts according to specifications and lower the engine onto the crossmember.
- Step 6
Reattach the remaining engine components in reverse order, attaching the negative battery cable last. Fill the crankcase with fresh oil, and check the level with a dipstick. Subaru Outbacks require between 5.5 and 6 qt.
- Step 7
Funnel the old oil into an empty milk carton and take it to a garage or to your local hazardous waste facility for proper disposal.
Car Repair | Car Diagnosis | Brake Repair | Transmission Repair | Trouble codes | car repair problems | auto insurance question | Car Logos Pictures |