How to Replace a Power Mirror in a Mazda 626

Raise the door glass with the rear edge at approximately 3 1/2 inches higher than the completely lowered position. Take the regulator handle off if window is manually operated.

Take the screws out, and remove the fasteners that holds the Mazda's door trim panel. Use your hands or a cloth-covered screwdriver to remove the trim.

Pull the door trim up to dislodge the hooks holding it in place.

Disconnect the power window connector, small light and trunk lid-opener switch connectors.

Peel the corner of the screen back near the interior mirror assembly.

Unplug the mirror connector. Remove the nuts to free the old mirror from your Mazda 626.

Put the new mirror in place. Attach the nuts to secure it. Restore the power connection.

Put the screen cover on the 626 back in place.

Install the interior door trim panel in the reverse order.

Connect the negative battery cable. Check you power mirror to make sure it functions.