How to Replace a Power Mirror in a Dodge Intrepid

Disconnect the negative battery cable before you take the front door trim panel off the Intrepid door. Remove all screws and clips and carefully prying the panel from the door.

Slide the front window trim off, and unplug the Intrepid's mirror power connector.

Pull the cover off the mirror assembly to allow access to all nuts and bolts.

Remove the nuts on the mirror and door frame, and take the harness plug out while feeding the wire through the hole.

Take the old power mirror off the door of the Intrepid.

Feed the new power mirror wire through the hole and connect the harness plug.

Put the new Intrepid mirror against the door frame and replace the nuts. Tighten all nuts until the mirror fits snugly in place.

Replace the window frame trim by sliding in back into place.

Install the door trim panel, and reconnect your battery cable.